![]() ![]() ![]() I suppose you would be networking between the two systems on one computer But how the hell you achive that I'm afraid I dont know. The other point you raised about being able to swap files would be a no no.But lurking in my head is a discussion I had once about duel booting a machine so that you can. Redsail vinyl cutter RS360C, RS450C, RS500C, RS720C, RS800C, RS1120C & RS1360C and SignMax, SignWarehouse Cutting Plotter. ![]() Install the driver and insert the softdog into your computer, you can output your image from CorelDraw directly. Most of the cheap progs need to format the hard drive first unless thier is better software than when I last done it I would think that there has to be a casmate genius that can sort this out for you somewhere. CorelDraw Driver CutMate 2.3 with Softdog For Vinyl Cutter Cutting Plotter. Hi Phil You can partion the hard disk without losing your information but you need special software for this and they do state that it is still high risk. 2/ If I do partition the drive as you suggest - when switching on and electing to boot up from the hard drive with windows 98 installed - will I be able to open and save files installed on the drive with windows xp? (and vice versa) or do I need to boot up again everytime I want to access files on one or other drives? Your network suggestion is what I am already doing - but I was hoping to be able to run Casmate from the new PC which is a laptop - and therefore easily transported to work at home when I want to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |